Accu-Chek Active GB User Manual

10
Blood Glucose Tests4
Test Strip in the Meter
Apply the blood drop
to the center of the
test area and then
remove your finger
from the test strip.
As soon as the meter
detects the blood,
the meter beeps.
The flashing hourglass symbol
indicates
that the test is in progress.
If the amount of blood you applied is
insufficient, 3 beeps will sound after a few
seconds. You can apply an additional
amount of blood.
The test is over in approx. 5 seconds.
Proceed to step 11.
Test Strip outside the Meter
When the test strip
symbol and the
flashing drop symbol
appear: Remove the
test strip from the
meter.
The test strip and
drop symbol flash on
the display. You have
approx. 20 seconds
to apply blood to the
test strip and to
reinsert it into the
meter.
Apply the blood drop to the center of the
test area.
Insert the test strip
into the test strip
guide in the direction
of the arrows with
the test area facing
up.
7
8
9
10
The test strip must lie flat on the
measurement window cover.
If you do not reinsert the test strip
moistened with blood into the meter within
the available time, a beep sounds once per
second during the last 5 seconds.
The test starts. The flashing hourglass
symbol
indicates that the test is in
progress.
The test is over in approx. 8 seconds.
Test Result
The test result
appears on the
display and the
meter beeps. The
meter automatically
saves the test result.
Remove the test strip
from the meter.
The meter turns off.
Discard used test
strips according to
local regulations.
Healthcare
professionals must
discard used test strips according to the
hygiene and safety policy of their laboratory
or institution.
11
12
FOM_09262946001_01_EN_ROW.indd 10 24.03.2020 09:48:21

Accu-Chek Active GB Specifications

General

Brand	Accu-Chek
Model	Active GB
Category	Blood Glucose Meter
Language	English