Page 30 of 39
In-service plan for blood glucose testing
Fill in the blanks.
15. Where are the expiration dates for test strips and control solutions found?
16. Where can a troubleshooting guide for the ACCU-CHEK Inform II system be found?
17. “HI” on the ACCU-CHEK Inform II system display indicates that the blood glucose value is
over mg/dL, and the result may be the reading range of the meter.
18. “LO” on the ACCU-CHEK Inform II system display means the blood glucose is below
mg/dL, and the result may be the reading range of the meter.
19. What type(s) of blood can be used with the ACCU-CHEK Inform II meter and
ACCU-CHEK Inform II test strips?
20. ACCU-CHEK Inform II control solutions are stable for months after opening.
21. If patient results are higher than mg/dL or lower than mg/dL,
a lab backup should be ordered.
22. ACCU-CHEK Inform II test strips are stable until the expiration date listed on the
23. The proper ngerstick procedure is
To Next Page
Loading...
