AccuCut MARK IV - Cutting Materials & Layers

To Next Page

To Previous Page

CUTTING MATERIALS & LAYERS

Cutting Materials & Layers

Here’s What You Can Cut with an AccuCut

Machine!

NOTE: Numbers of layers listed are estimates only and depend on actual thickness of materials. To

determine actual number of layers, start with one layer and test the cut, then add one layer at a time,

testing cut again each time. When blade no longer cuts all the way through a stack of material, remove

a layer or two and proceed with cutting.

Recommended Number of Layers

Lightweight Paper 6-8 4-6

Construction Paper 4-6 4

Laminated Paper 3 1-2

Cardstock 3-4 2-3

3-D Plastic 1-2 1

Poly Foam 2 1

Mat Board 1 1

Sponge 1 1

Flexible Magnetic

Sheets

2 1

Cling Vinyl 2-4 2

Fabric 6 4

Simple Die Designs:

Simple outlines, no extra embellishments such

as perforation or punches.

Intricate Die Designs:

Detailed outlines or extra embellishments

such as perforation or punches.

Material