Accuphase E-212 User Manual

Attention mark indicating critical components for safety.
Replacement must be made with identical parts of special part number.
このマークのついている部品は、安全上重要な部品です。
必ず指定されている部品番号の部品を使用して下さい。
Authorized Technical Service Only
These servicing instructions are for use by qualified personnel only.
To reduce the risk of electric shock do not perform any servicing
other than that contained in the operating instructions unless you are
qualified to do so. Refer all servicing to qualified service personnel.
ここに記載したサービスに関する指示事項は、サービスに関する資格を
有する者のみが使用するものです。感電防止の観点から、サービス資格
を有していない方は、取扱指示事項以外のサービスは絶対に行わないよ
うにして下さい。
CAUTION /
回路図

Accuphase E-212 Specifications

General

Power Output	60 W + 60 W (8 Ω)
Frequency Response	20Hz to 20kHz
Signal-to-Noise Ratio	90dB (MM), 100dB (line)
Output	Speaker terminals
Speaker load impedance	4 Ω to 16 Ω
Input Sensitivity	200 mV

Summary

Authorized Technical Service Only

Servicing Safety Precautions

Essential safety warnings for technicians regarding electric shock and proper servicing procedures.

Critical Component Safety Identification

Highlights critical safety components and the necessity of using specified replacement parts.

Circuit Adjustment Procedures

Power Amplifier Bias Current Adjustment

Detailed steps for adjusting the bias current on the power amplifier assembly for optimal performance.

Meter Calibration Guide

Instructions on how to calibrate the unit's meters for accurate readings.

AC Line Voltage Selection Guide

Product Packing and Contents

Master Circuit Diagram Overview

Accuphase E-212 Technical Specifications