Accurex XXSV - User Manual

Questions and Answers

S
Spencer SosaAug 3, 2025
How to troubleshoot Accurex XXSV Ventilation Hood exhaust fan not working?
- S
  Sarah WeaverAug 4, 2025
  If the Accurex Ventilation Hood exhaust fan isn't working or isn't reaching the intended performance, you can try the following: replace any blown fuses, reset tripped circuit breakers, and verify the disconnect switch. Also, inspect the belt and replace or tighten if necessary. Ensure that the fan is correctly wired by a qualified electrician. Clean the fan wheel/blade, replace the fan wheel if damaged, and check for loose bolts, broken components, or any obstructions. If needed, adjust or replace the pulleys to increase the fan RPM or install a larger motor.
N
Nicholas JohnsonAug 12, 2025
Why does smoke blow away from my Accurex XXSV?
- C
  choganAug 12, 2025
  If smoke blows away before reaching the bottom of your Accurex Ventilation Hood, try these solutions: turn off or redirect any fans causing drafts. Move diffusers or replace them with ones that direct air away from the hood. Close windows and doors to minimize drafts. Identify and eliminate any sources of drafts, and consider adding side skirts to the hood. Also, increase the overhang on the spillage side, and add a 6-inch lip around the base of the hood. Ensure make-up air is evenly distributed throughout the kitchen. Adjust the amount and locations of make-up air to eliminate drafts through pass-thru windows. You can also try turning off or reducing the amount of make-up air, or blocking off portions of the supply to direct air away from the problem area by testing with cardboard.
S
Stacey MendezAug 16, 2025
What to do if Accurex XXSV Ventilation Hood blows out pilot lights?
- S
  Spencer MendozaAug 16, 2025
  If pilot lights are being blown out or cooking equipment is being cooled by make-up air under your Accurex Ventilation Hood, consider these adjustments: Try reducing the amount of make-up air, or block off portions of the supply to redirect air away from the cooking equipment. Remove any obstructions in front of the supply that are directing air towards the cooking equipment.
K
Kathy DunlapAug 20, 2025
Why is there cold air at my Accurex Ventilation Hood?
- S
  suarezleroyAug 21, 2025
  If you feel cold air at the Accurex Ventilation Hood, it could be due to air short-circuiting. Try reducing the amount of air supplied to the short circuit, or reducing the amount of air supplied to the air curtain. You might also try reducing the amount of make-up air or heating the supply air.
S
stephanie70Aug 25, 2025
How to cool down kitchen with Accurex XXSV Ventilation Hood?
- M
  Michael SolisAug 26, 2025
  If the kitchen is getting too hot while using the Accurex Ventilation Hood, you can try turning off or reducing the amount of air supplied to the air curtain. Another option is to reduce the amount of make-up air or cool the supply air.
S
smithstephanieAug 29, 2025
Why is grease running off my Accurex XXSV?
- J
  Julia HarveyAug 29, 2025
  If grease is running off the Accurex Ventilation Hood, it could be due to a few reasons. Check if the exhaust duct is correctly welded. Clean the affected area and recaulk if necessary. Also, ensure the grease cup is properly in place.
T
Tiffany ButlerNov 6, 2025
What to do if my Accurex XXSV Ventilation Hood is full of smoke?
- T
  tategreggNov 7, 2025
  If your Accurex Ventilation Hood is full of smoke, or smoke is escaping from the edges, several factors could be at play. First, ensure the exhaust fan is functioning correctly. Clean or replace dirty or damaged filters, making sure they are correctly positioned. Check the make-up air unit, increasing the amount of make-up air, and ensuring it's evenly distributed. Adjust or replace the fan to match the cooking equipment load. You may also want to restrict a second hood to help the problem hood, or open dampers. In addition, refer to the test and balance report, design specifications, and fan curves; have an electrician check the motor amperage; try removing the filter temporarily to see if capture improves (Make sure to replace filter to prevent risk of fire!); switch to different filters...