Accurex XXEW - User Manual

Questions and Answers

D
daniel09Aug 13, 2025
What to do if my Accurex XXEW Ventilation Hood is full of smoke?
- A
  amandabrooksAug 13, 2025
  If your Accurex Ventilation Hood is full of smoke, start by consulting the exhaust fan troubleshooting section. An electrician can check the motor amperage, and you can temporarily remove the filter to see if capture improves. Consider switching to filters with lower static pressure or cleaning, replacing, or properly positioning the existing ones. Ensure the make-up air unit is functioning correctly, increasing make-up air if needed, and ensuring it's evenly distributed. Adjust or replace the fan to match the cooking equipment load, restrict a second hood to assist the problem hood, open dampers, change to a higher static fan, modify the ductwork, or clear any obstructions.
L
Linda SloanAug 17, 2025
How to eliminate cooking odors in the dining area caused by Accurex XXEW?
- S
  Sarah NicholsAug 17, 2025
  If you're experiencing cooking odors in the dining area, consult the sections on fan performance and hood capture. You can also try decreasing make-up air in the kitchen and increasing exhaust air through the hood.
W
webbjefferyAug 21, 2025
Why is the exhaust fan on my Accurex Ventilation Hood not working?
- H
  Hunter WeaverAug 21, 2025
  If the exhaust fan of your Accurex Ventilation Hood isn't working correctly, replace fuses, reset circuit breakers, and check the disconnect. Replace or tighten the belt. Have an electrician correctly wire the fan. Consult the manufacturer's installation manual. Adjust or replace pulleys to increase fan RPM or install a larger motor. Clean the fan wheel/blade, replace it if damaged, check for loose bolts, broken or damaged components, and remove any foreign objects.
C
calderonrichardAug 25, 2025
How to stop grease from running off my Accurex XXEW Ventilation Hood?
- M
  Mikayla GutierrezAug 26, 2025
  To stop grease from running off your Accurex Ventilation Hood, ensure the exhaust duct is correctly welded. Clean the problem area and recaulk it. Also, make sure the grease cup is in place.
J
Jeremy MartinezAug 28, 2025
How to reduce noise from my Accurex XXEW?
- H
  Hannah BuchananAug 29, 2025
  If the Accurex Ventilation Hood is noisy, consult the exhaust fan troubleshooting section. Replace any missing filters, or try slowing down the fan.
K
Kevin DunnSep 1, 2025
What to do if smoke blows away from my Accurex XXEW Ventilation Hood?
- M
  Mary WagnerSep 1, 2025
  To resolve smoke blowing away before reaching the bottom of the Accurex Ventilation Hood, turn off or redirect fans. Move diffusers to a more neutral area or replace them with diffusers that direct air away from the hood. Close windows and doors. Find and eliminate the source of the draft, add side skirts to the hood, increase the overhang on the spillage side, or add a 6-inch lip around the base of the hood. Adjust the amount and location of make-up air to eliminate drafts through pass-thru windows. Try turning off or reducing the amount of make-up air and block off portions of the supply to direct air away from the problem area.
C
Carrie MillerSep 4, 2025
Why is my Accurex XXEW blowing out pilot lights?
- W
  William DiazSep 5, 2025
  If pilot lights are being blown out or cooking equipment is being cooled by make-up air from your Accurex Ventilation Hood, try turning off or reducing the amount of make-up air and block off portions of the supply to direct air away from the problem area.
K
Keith BrownSep 8, 2025
Why is cold air blowing from my Accurex XXEW?
- W
  Wesley SimmonsSep 8, 2025
  If you feel cold air at the hood, try turning off or reducing the amount of air supplied to the air curtain, or heat the supply air.