12
1.
NOTICE:
Checking before use-season
4.
5.
Check whether air inlets and air outlets are bl-
D
o not remove the panel when cleaning it.
C
heck whether drainage pipe is damaged.
in good condition.
3.
Check whether filter is clean.
Check whether mounting bracket for outdoor
NOTICE
●
●
ocked.
2.
Check whether air switch, plug and socket are
unit is damaged or corroded . If yes, please
contact dealer.
NOTICE:
Checking after use-season
1.
2.
3
.
Clean and maintenance
■
2.
■
WARNING
WARNING
■
If
there're other error codes, please contact qu-
alified profess ionals for service.
■
■
■
■
Error Code
Error code
F2
E8
D
isconnect power supply.
Clean filter and indoor unit’s panel.
P
lease contact qualified professionals for
service.
C5，F0，F1，
Notice for recovery
T
roubleshooting
1
.
U8，H6，H3，
E1，E5，E6，
M
any packing materials are recyclable mate-
C
heck whether mounting bracke t for outdo
o
r
u
nit is damaged or corroded. If yes, please
c
ontact dealer.
C
lean surface of indoor unit
W
hen the surface of indoor unit is dirty, it is recomm-
ended to use a soft dry cloth or wet cloth to wipe it.
T
he filter should be cleaned every three months .
If there is much dust in the operation environme-
nt,
clean frequency can be increased.
Afte
r removing the filter, do not touch fins to
avoid injury.
Do not use fire or hair dryer to dry the filter to
avoid deformation or fire hazard.
rials. Please dispose them in appropriate
recycling unit.
If you want to dispose of the air conditioner,
please contact local dealer or consultant service
center for the correct disposal method.
NOTE
It
can be eliminated after restarting the unit.
If not, please contact qualified professionals
for service.
When air conditioner status is abnormal, tempe-
r
ature indicator on indoor uni t will blink to display
c
orresponding error code. Please refer to below
l
ist for identification of error code.
2.
4.
Clean filter
1.
3.
●
●
Open panel
P
ull out the panel
t
o a certain angle
a
s shown in the fig.
Remove filter
R
emove the filter as
indicated in the fig.
T
urn off the air conditioner and disconnect the
power before cleaning the air conditioner to av-
oid electric shock.
Do not wash the air conditioner with water to
avoid electric shock.
Do not use volatile liquid to clean the air
conditioner.
D
o not use liquid or corrosive detergent to clean
the appliance and do not splash water or other
liquid onto it , otherwise , it may damage the
plastic components , even cause electric shock.
Install filter
Install the filter and then close the panel cover
t
ightly.
Clean filter
U
se dust catcher or water to clean the filter.
When the filter is very dirty, use the water
(below 45℃) to clean it , and then put it in a
shady and cool place to dry.
To Next Page
Loading...
