21
Advanced Setup
The following screen shows the Advanced Setup:
The following table describes the parameters found in this menu.
Parameter Description Options
Quick Boot Allows BIOS to skip certain tests while
booting. This will decrease the time needed
to boot the system
[Enabled],
[Disabled]
1 st Boot Device The item allows you to see the sequence of
boot device where BIOS attempts to load
the disk operation system.
Hard Disk Drive
Priority
Specifies the boot device. Priority
sequence from available Hard Drives
Boot up Num-Lock On Select Power-on state for Numlock On,Off
USB Beep Message Enables the beep during USB device
enumeration
[Enabled],
[Disabled]
Quick Boot Enabled
Quiet Boot Enabled
1st Boot Device [HDD:P0-Hitachi HTS]
Hard Disk Drive Priority [Press Enter]
Boot up Num-Lock On
USB Beep Message Disabled
Boot to BoxShell Disabled
Item Help
KLIJ: Move Enter: Select +/-/: Value F10: Save ESC: Exit
F1: General Help F9:
Optimized Defaults
CMOS Setup Utiliyt – Copyright (c)
To Next Page
Loading...
