72 Chapter 3
Replacing the USB/LED/Power/Card Reader Board
IMPORTANT:Before installing the USB board, take care of the following items:
• Check that LED isn`t broken
• SLIDER work smoothly
1. Connect the cable to the board. 2. Turn the board over and place it in the lower case.
3. Replace the three or four screws (depending on SKU) to secure the module.
4. Connect the FFC cable to the module and close
the cable latch.
5. Connect the FFC cable to the mainboard and close
the cable latch.
HDD SKU
SSD SKU
To Next Page
Loading...
