Machine Maintenance Procedures 3-13
2. Lift up the base assembly by starting from the bottom edge of the base assembly.
Refer to Figure 3-8.
3. Release the tabs on the bottom edge of the base assembly. (Figure 3-8).
4. Grasp the base assembly and remove the base assembly from the device (Figure 3-8).
Figure 3-8. Base Assembly Removal
Base Assembly Installation 0
1. Align the base assembly onto the device (Figure 3-8).
2. Install and secure twenty four (24) screws to the base assembly. Refer to Figure 3-7.
3. Install battery.
ID Size Quantity Screw Type
Green
Call
out
M2.0*3.0 6
Red
Call
out
M2.5*6.5 18
To Next Page
Loading...
