32 Chapter 2
DOS Flash Utility
Perform the following steps to use the DOS Flash Utility:
1. Press F2 during boot to enter the Setup Menu.
2. Select Boot Menu to modify the boot priority order, for example, if using USB HDD to Update BIOS, move
USB HDD to position 1.
3. Execute the BIOS.BAT batch file to update BIOS.
The flash process begins as shown.
Item Specific Help
Use < > or < > to select
a device, then press
<F5> to move it down the
list, or <F6> to move
it up the list. Press
<Esc> to escape the menu
F1
ESC
Help
Exit
Select Item
Select Menu
Change Values
Select SubMenu
Enter
F9
F10
Setup Default
Save and Exit
Boot priority order:
1. Network Boot : LEGACY PCI DEVICE
2. USB FDD :
3. IDE0 : WDC WD5000BEVT-22A0RT0
4. USB HDD :
5. USB CD/DVDROM :
6. IDE1 : HL-DT-STDVDRAM GT30N
Boot priority order:
1. Network Boot : LEGACY PCI DEVICE
2. USB FDD :
3. IDE0 : WDC WD5000BEVT-22A0RT0
4. USB HDD :
5. USB CD/DVDROM :
6. IDE1 : HL-DT-STDVDRAM GT30N
F5/F6
InsydeH20 Setup Utility Rev. 3.5
Information
Main Boot
Exit
Security
To Next Page
Loading...
