Chapter 3 55
NOTE: The following is the correct cable-color to connector designation: TR1 (left) to White, TR3 (middle) to
Gray, and TR2 (right) to Black.
5. Move the cables away to avoid damaging the them, and remove the two screws on the WLAN board to release
the WLAN board.
6. Detach the WLAN board from the WLAN socket.
Removing the Hard Disk Drive1 Module
1. Remove the Battery Pack. See “Removing the Battery Pack” on page 46.
2. Remove the HDD1 cover. See “Removing the Lower Covers” on page 49.
Step Size Quantity Screw Type
WLAN Module M2*3 (NL) 2
To Next Page
Loading...
