Chapter 3 63
Removing the Switch Cover
CAUTION: Using tools to remove the Switch Cover may cause damage to the outer casing. It is
recommended that only fingers are used to remove the Switch Cover.
1. Remove the Battery Pack. See “Removing the Battery Pack” on page 46.
2. Locate and remove the nine securing screws as shown.
3. Turn the computer over and open the LCD module fully to expose the Switch Cover.
4. Lift the Switch Cover up and away.
Step Size Quantity Screw Type
Switch Cover M2.5*3(NL)
Blue Callout
4
Switch Cover M2.5*6.5(NL)
Red Callout
5
To Next Page
Loading...
