Machine Maintenance Procedures 3-19
Palm Rest Cover Installation 0
1. Place the palm rest cover (C) face down on the keyboard. Refer to Figure 3-16.
2. Connect Touchpad FPC (A) to Touchpad connector (B). Refer to Figure 3-16.
3. Turn the palm rest cover over and align it properly to the edge of the system.
4. Install and secure eight (8) screws to the palm rest cover on the bottom of the system.
Refer to Figure 3-15.
5. Install HDD Module.
ID Size Quantity Screw Type
Red
Call out
M2.5*6 7
Green
Call out
M2*3 1
To Next Page
Loading...
