Disassembly Procedures 1-11
Touchpad Module Removal 0
Prerequisite:
Battery Pack Removal
1. Locate the touchpad module (G) on the top assembly. Refer to Figure 1-9.
2. Peel off the adhesive tape from the touchpad connector (Figure 1-12).
Figure 1-12. Touchpad Tape Removal
3. Disconnect the touchpad FFC (B) from the touchpad connector (A) and the
mainboard connector (C) then remove the touchpad FFC from the top assembly
(Figure 1-13).
Figure 1-13. Touchpad FFC Removal
To Next Page
Loading...
