- 39 -
5.2 Software / Firmware Upgrade Process
5.2.1 Hardware prepared:
Hardware Requirement:
1. ISP board x 1
2. DSUB VGA cables x 2
3. Printer cable (with one male connector and another female connector) x 1.
4. PC or Notebook with parallel (printer) port x1.
Connect to target monitor
VGA signal input from 15pin D-sub
cable of PC or NB.
Connect ISP board and
PC with printer port cable
Check the Jumpers on the
ISP Circuit Board (make
sure J5, J6, J7, J8 are set
at ping 1,2 )
To Next Page
Loading...
