5-3
Exporting Log and Writing SN 0
This chapter explains how to use the “Log Tool” to get the log files of the device information
from the tablet and use the SN writer tool to write or change the SN information of the tablet.
When your tablet appears some error, you can use the Log Tool to catch and export the
running log files, then get some information from them.
Tool Installation 0
For exporting log files, you should install the Log Tool on the tablet first. Please operate
following the instructions.
Step 1:
Open the “a110” folder on the desktop and open the “adb.1” folder in it.
Figure 5-1. Enter the adb.1 folder.
Step 2:
Open the tablet and connect it to the PC by USB cable.
Step 3:
Run the bat file named “setup logtool”. Waiting for sometime until it has finished the
installation. Then press any key to end the process.
Figure 5-2. Find and run the “setup logtool.bat”.
To Next Page
Loading...
