3-5 Service and Maintenance
Getting Started
The flowchart (Figure 3:1, page 3-4) identifies sections illustrating the entire removal and
installation sequence. Observe the order of the sequence to avoid damage to any of the hardware
components.
Perform the following prior to performing any maintenance procedures:
1. Place the system on a flat work surface.
2. Disconnect the AC Adapter and remove all cables from the system and its peripherals.
3. Make sure the system is completely powered down.
4. To make sure the system is completely powered down, press and hold the Power button for 3
seconds.
Figure 3:2. Device Overview with Power Button
5. On the Power Off dialog box, tap OK.
To Next Page
Loading...
