Acer PD726 - Page 24

Chapter2 18
No Step Procedure Photo
3 Key in
Serial
Number
1. Key in the Serial
Number into the
Barcode blank space.
2. In “Write Source
Select”, make a check
in “Analog” and
“Digital”.
3. Click “Program”.
4 Change
Cable to
Analog
“Please change the
Cable to Analog” mes-
sage is shown on the
screen, then click “OK”.
(Note: “RUN” mes-
sage will appear on the
screen.)
5 Change
Cable to
Digital
“Please change the
Cable to Digital” mes-
sage is shown on the
screen, then click “OK”.
(Note: “RUN” mes-
sage will appear on the
screen.)
6 Finished
When the EDID program
is completed, the mes-
sage, “OK”, will appear
on the screen.
2
1
3