English
A. Hardware connection:
1. Guide to components
2. Turn on the projector
3. Check the information on the splash
screen
Check Projector ID, Projector Name (SSID),
Server IP and WEP on the splash screen. The
Server IP will be assigned by the network
with DHCP enabled. Ask your supervisor for
the wireless connection WEP key when WEP is
enabled.
4. Connect to network
a Switch on your system, and activate your
wireless LAN.
b Scan for avaliable WLAN APs using your
preferred WLAN manager.
c Select and connect to the access point labeled
AcerProjector, or AcerProjectorXXXX.
d Connect the projector to your LAN for a wired
connection.
B. Software installation:
1. The software is stored on the Acer
Projector Gateway.
Please follow the steps below to
download and install:
a Open the internet browser.
b You will automatically be taken to the
welcome page.
c Enter the Server IP address into your browser’s
address bar if you do not see the welcome
page.
1 Mini USB
2 LAN port
3 USB Type A
Projector ID: 7362
Projector Name (SSID) : AcerProjector 001
Server IP : 192.168.100.10
WEP Key : None
321
To Next Page
Need help?
General
