English
LCD Monitor Quick Setup Guide
Acer LCD Monitor Quick Start Guide (QSG)
Important safety instructions
Please read the following instructions carefully.
1. To clean the LCD monitor screen:
• Turn off the LCD monitor and unplug the power cord.
• Spray a non-solvent cleaning solution onto a rag and clean the screen gently.
2. Do not place the LCD monitor near a window. Exposing the monitor to rain, moisture or sunlight can severely damage it.
3. Do not apply pressure to the LCD screen. Excessive pressure may cause permanent damage to the display.
4. Do not remove the cover or attempt to service this unit yourself. An authorized technician should perform servicing of any nature.
5. Store the LCD monitor in a room with a temperature of -20° to 60°C (-4° to 140°F). Storing the LCD monitor outside this range may
result in permanent damage.
6. Immediately unplug your monitor and call an authorized technician if any of the following circumstances occur:
• Monitor-to-PC signal cable is frayed or damaged.
• Liquid spills onto the LCD monitor or the monitor is exposed to rain.
• The LCD monitor or case is damaged.
Package contents
LCD monitor Power cord
Audio cable
(Optional)
VGA cable
(Optional)
DVI cable
(Optional)
DP cable
(Optional)
Quick start
guide
LCD monitor
Attaching the monitor to the base
1. Remove the monitor base from the packaging and place it on a stable and level workspace.
2. Remove the monitor from the packaging.
3. Align the release button at the buttom of the monitor with the corresponding slot at the bottom of the base. A clicking sound signies
that the monitor has been securely attached to the base.
Connecting Your Monitor to a Computer
1. Turn off your computer and unplug your computer’s power cord.
2. Connect the signal cable to the VGA and/or DVI-D (optional) and/or DP
(optional) input socket of the monitor, and the VGA and/or DVI-D (optional)
and/or DP (optional) output socket of the graphics card on the computer.
Then tighten the thumbscrews on the signal cable connector.
3. Optional:Connect the audio input socket(AUDIO IN) of the LCD monitor and
the line-out port on the computer with the audio cable.
4. Insert the monitor power cable into the power port at the back of the monitor.
5. Plug the power cords of your computer and your monitor into a nearby
electrical outlet.
AUDIO IN
VGA
DP
DVU-IN
To Next Page
Need help?
General
