Acer V223HQ - Declaration of Conformity (EU); EU Declaration of Conformity; Compliance Standards

Acer Acer –LCD-B&V223HQ
10
Notes: Other second source panel please refer to the panel specifications.
5.1.2 LCD module defects
LCD module defects check follows IIS. Details refer to panel approval sheet.
Keypad Function
5.1.3
Control buttons
[AUTO]
A. When OSD un-displays, press [AUTO] to perform auto-adjustment
B. When OSD displays, press [AUTO] to return to previous level menu
C. When “e Color OSD” OSD displays, press [AUTO] to exit the OSD
[MENU]
A. When OSD isn’t shown on screen, press [MENU] to enter OSD interface.The OSD
interface uses “ACER eColor Management” and “User” to instead “Contrast” and
“Brightness” separately.When press “ACER eColor Management” to show “e Color
OSD”,and press “User” to show OSD interface before. The translations of “ACER
eColor Management” and “User” are always English.
B. When OSD displays, press [MENU] to perform function of menu icon that is
highlight or enter next level menu
[►], [◄]
A. When “MENU OSD” displays, press these keys to change the contents of an
adjustment item, or change an adjustment value
B. When “MENU OSD” un-displays, if it is with audio, press [►] to show “Audio” OSD
and increase the volume, press [◄] to show “Audio” OSD and decrease the
volume; else it has no use to press these keys.
[e Color ]
A. When OSD un-displays, press [e Color] to show “e Color OSD”,and press again
the OSD can not disappear,but the time of “e Color OSD”disappearing is reseted
10 second again.
B.When OSD disappear not including “e Color OSD”,press [e Color] to show “e Color
OSD” OSD,the OSD before disappears,but the parameters of it should be saved
[POWER] Power on or power off the monitor
5.1.4
Hot Key Operation
HOT KEY OPERATION
FUNCTION
e Color AUTO MENU ◄ ► POWER
DESCRIPTION
FACTORY
MODE
● ON
Press [e Color] and then press [POWER]
for DC power on. OSD menu will be
shown with “F” on the left top. Select “F”
for entering factory mode.
5.2 OSD Structure
The On-Screen Display (OSD) shall be an easy to use icon based menu through keypad OSD buttons or remote
control unit. The unit shall leave the factory with all OSD controls set to their
default values.
First Second Third
C
on
t
ro
l
Range
Default Value
ACER eColor
Management
e
mpower
i
ng
T
echnolo
---
Standard mode
Brightnes
s
User
Contrast
0 ~ 100
User mode
50