1. Turn off the computer power and unplug the computer power cord.
2. Connect one end of the signal cable to the VGA/HDMI input jack on your monitor and the other
end to the VGA/HDMI input jack on your computer's graphics card. Tighten the finger screws on
the signal cable (VGA) connector.
3. Plug the adapter power cord into the power port on the back of the monitor.
4. Plug the computer power cord and monitor adapter into a nearby power outlet.
Installing monitor
1. Remove the monitor bracket and base from the packaging and place it on a stable and level workspace.
2. Open or close the rear bracket. The viewing angle of the monitor can be adjusted using the stand.
(As shown below)
3. Support wall hanging function, VESA100*100mm, M4*10 screws.
Connect the monitor to your computer
English
Acer LCD Monitor Quick Start Guide (QSG)
Important safety instructions
Please read the following instructions carefully.
1. To clean the LCD monitor screen:
•
• Spray a non-solvent cleaning solution onto a rag and clean the screen gently.
2. Do not place the LCD monitor near a window. Exposing the monitor to rain, moisture or sunlight can
severely damage it.
3. Do not apply pressure to the LCD screen. Excessive pressure may cause permanent damage to the display.
4. Do not remove the cover or attempt to service this unit yourself. An authorized technician should perform
servicing of any nature.
5. Store the LCD monitor in a room with a temperature of -20° to 60°C (-4° to140°F). Storing the LCD monitor
outside this range may result in permanent damage.
6. Immediately unplug your monitor and call an authorized technician if any of the following circumstances
occur:
• Monitor-to-PC signal cable is frayed or damaged.
• Liquid spills onto the LCD monitor or the monitor is exposed to rain.
• The LCD monitor or case is damaged.
Package contents
LCD monitor Adapter/Power lineStand/Base
VGA/HDMI cable
(Optional)
Quick start guide
USER GUIDE
LCD monitor V6 Series-V226HQL
To Next Page
Loading...
Need help?
General
