Chapter 2 41
Integrated Peripherals
All onboard peripherals can be set up through this menu.
On-Chip Primary PCI IDE [Enabled]
Item Help
On-Chip Secondary PCI IDE [Enabled]
Menu Level X
On-Chip SATA Mode [Auto]
PATA IDE Set to Ch. 1 Master/Slave
SATA Port0/2 Set to Ch. 0 Master/Slave
SATA Port1/3 Set to Disable
USB Controller [Enabled]
USB 2.0 Controller [Enabled]
USB Keyboard Support [Enabled]
USB Mouse Support [Enabled]
Azalia Codec [Auto]
Onboard H/W LAN [Enabled]
Onboard LAN Boot ROM [Enabled]
Onboard Parallel Port 1 [378/IRQ7]
Onboard Parallel Port 2 [2F8/IRQ3]
UART Mode Select [Normal]
UR2 Duplex Mode Half
TxD, RxD Polarity Active Lo, Hi
Use IR Pins IR-Rx2Tx2
Onboard Parallel Port [378/IRQ7]
Parallel Port Mode [PRINTER]
ECP Mode Use DMA 3
CMOS Setup Utility-Copyright © 1984-2005 Award Software
Integrated Peripherals
KLIJ: Move Enter: Select +/-/PU/PD: Value F10:Save ESC: Exit F1: General Help
F5: Previous Values F7: Default Setting
To Next Page
Loading...
