Jumper and Connector Information
Jumper Setting
This section explains how to set jumpers for correct configuration of the motherboard.
Setting Jumper
Use the motherboard jumpers to set system configuration options. Jumpers with more than one pin are
numbered. When setting the jumpers, ensure that the jumper caps are placed on the correct pins.
Description illustration
The illustrations show a 2-pin jumper. When the
jumper cap is placed on both pins, the jumper is
SHORT. If you remove the jumper cap, or place the
jumper cap on just one pin, the jumper is OPEN.
SHORT OPEN
This illustration shows a 3-pin jumper. Pins1 and 2
are SHORT.
Do not over-tighten the screws as this can stress the motherboard.
Chapter5
To Next Page
Loading...
