4 Chapter 1
• 6 SATAII connectors.
• Four 2*5 pin Intel FPIO specification USB pin connectors (follow Intel FPIO standard Specification).
• One 2*5 pin Intel FPIO spec. Microphone In/ Headphone Out pin connectors.
• One serial port 2*5 pin connector (COM2).
• One 4 pin CPU Fan connector.
• One 3 pin System Fan connector with linear circuit.
• One 4 pin SPDIF header closed to PCIEx16 slot.
• One 24 pin ATX interface PS3/PS2 SPS connector, 4 pin CPU power connector.
• One 2*7 pin front panel IO header.
• One Jumper for clear CMOS.
• One on board buzzer.
• One 2pin OBR connector.
• Two reserve 2pinGPIO connector.
• One 2pin Intrusion Alarm connector.
• One LPT 2*13pin header (near rear IO is preferable).
• One 2*4 pin internal speaker header.
• Braidwood slot (reserved).
• One 3pin ME enable/disable header.
System BIOS
• Use SPI Flash
• Size: 64Mb(Piketon vPro).
• Kernel:AMI Kernel with Acer skin/copyright.
Power supply
• 300W/ in stable mode (Acer/GTW Assign System Power Unit).
• Design for Intel Piketon chipset compatible system.
• Voltage design should be covered +5V, +3.3V, +12V, +5VSB, -12V (attention to 12V output capability).
• Demand for both PFC/Non-PFC solutions.
• Minimum 4 Serial ATA power connector solution should be included (by default).
• Minimum 1 big 4-pin power connector included.
• Minimum 1 small 4-pin power connector included.
• PFC version will not provide switch selector for 115/230V AC input but it should be universal for Europe
and China.
• Non-PFC version should provide switch selector for 115/230V AC input and universal for worldwide.
• PS2 style.
• Compliant with Energy Star 5.0(Veriton M680 will not support Energy Star 5.0).
• Should be compliant with Eup lot6.
To Next Page
Loading...
