Acer XV273K - System Settings; Accessing System Menu; Navigating System Options; Adjusting System Parameters

English
------------------------------------------------------------------------------------------------------
Note:
------------------------------------------------------------------------------------------------------
Note:
------------------------------------------------------------------------------------------------------
Note:
6.
7.
8.
2.
3.
4.
5.
1.
9.
10.
System
HDMI Black level: Select to set HDMI black level.
DDC/Cl, short for Display Data Channel/Command Interface, which allows
monitor controls to be sent via software.
DDC/CI: Allows the monitor settings to be set through the software on the PC.
Hot Key Assigment: Select the function of shortcut key 1(Modes, Volume, Brightness,
Gamma, Contrast, Low Blue Light, Advanced Over Drive, VRB) and shortcut keys 2
(Modes,Volume, Brightness, Gamma, Contrast, Low Blue Light, Advanced Over Drive,
VRB).
Toggle the joystick to the up or down to select System from the OSD.Then toggle to the
right to navigate to the element you wish to adjust and press the joystick to enter it.
Press the MENU key to open the OSD.
Toggle to the left or right to control functions.
Input: Select the source from HDMI1, HDMI2, DP.
Surround application must set Auto Source is“Off”.
Auto Source: The default is "On”, which can support auto search for signal source in order.
Wide mode: You can select which screen aspect you are using. The options are Aspect /
Full / 1:1.
Quick start mode: Select Off or On. Turn on to speed up boot speed.
Picture
Color
Audio
OSD
Hot Key Assignment
DDC/CI
HDMI Black Level
System Quick Start Mode
DSC
Gaming
Standard
Mode
3840×2160
Resolution
60
Hz
HDMI1
Input
On
FreeSync Premium
Game Assistant
Wide Mode
Auto Source
Input
Enter
Move
X
11. DSC: The default is "On"; Support DP has DSC Function.
DSC = "On" is Default
• Only Support DP; HDMI to be gray out and unavailable.
• Can support max resolution must refer to the "Max Refresh Rate".
DSC = "Off"
• For some devices such as mobile phones, DSC needs to be set to
Off to display properly.
• Resolutions that can be supported will depend on the capabilities of
the graphics card, and may not be able to display 4K-(144/160)Hz.
• Some devices do not support DSC. If the display cannot be
displayed normally, please set DSC to Off.