ACES SYSTEMS Viper II - Tail Rotor Balance Process; Starting a New Job

Gen II User Manual
8-10 – Tail Rotor Balance Chapter 8 Revision 3.00, April 2020
8.3. – Tail Rotor Balance Process
The following paragraphs present the tail rotor balance process and its associated screens. It
is intended to familiarize the user with the data acquisition and correction capabilities of the
Gen II analyzers.
Prior to starting a new tail rotor balance job, you must first select the “Tail Rotor Balance”
option from the main menu by using the [] key and press [OK].
8.3.1. – Starting a New Job
Selecting “Start Job” from the “Tail Rotor Balance” banner screen allows you to begin a tail
rotor balance job. When you select this option, one of three screens will appear next