Gen II User Manual
14-24 – Vibration Spectrum Survey Chapter 14 Revision 4.10, Apr 2020
At this point you may select a new condition and repeat procedures starting from paragraph
14.1.7 until all required data are collected. If you would like to end the run with the ability to
resume it at a later time, press [F1] “Pause Job”. If you would like to exit the job without the
ability to resume it later, you can press the [F5] “Quit Job” key. Either of these actions will
cause the Shut Down Engines screen to be displayed as seen below. If you are finished
collecting data, shut down the engine(s) per the manual instructions and use the [F5] “Continue”
key to mark the job complete and store it to memory.
14.2. – Resume Job
The features in this section are common among all jobs. Because of this, they are contained in
Chapter 3, “Using the Gen II Analyzer”.
To Next Page
Loading...
