ACME Super Dotline - 03; Control Panel

- 8 -
03/ Control Panel
1. Display
To show the various menus and the selected function
2. Buttons
MENU
To enter into move backward or leave the menu
 UP
To go backward to move up in the menu
 DOWN
To go forward to move down in the menu
ENTER
To perform the desired functions
3. OFFLINE SETTING
4. FIRMWARE
UPGRADE
Used to upgrade fixture’s firmware
5. RESET
BUTTON
Used to reset the lock catch
6. LOCK CATCH
Used for splicing other fixtures
7. DMX IN
For DMX512 link, use 5-pin XLR cable to link the unit and DMX
controller to input DMX signal (3-pin XLR cable is optional)
8. POWER IN
To connect to supply power
9. ETHERNET
Transfers fixture’s information to a main controller
10. FUSE(T 15A)
Protects the unit from damage of over current or short circuit
11. POWER OUT
To connect to the next fixture
12. DMX OUT
For DMX512 link, use 5-pin XLR cable to link the next units to
output DMX signal (3-pin XLR cable is optional)
13. BOLT
Used to lock two fixtures