ACME TORNADO - Page 23

- 22 -
LED Use Hour
Humidity
Temperature
Fan State
Firmware Version
RDM UID
Select Humidity, press ENTER.
The device humidity is displayed.
To exit the menu, press MENU, or wait 30 seconds.
Select RDM UID, press ENTER.
The RDM UID is displayed.
To exit the menu, press MENU, or wait 30 seconds.
Select Firmware Version, press ENTER.
The firmware version is displayed.
To exit the menu, press MENU, or wait 30 seconds.
Select Fan State, press ENTER.
The fan status is displayed.
To exit the menu, press MENU, or wait 30 seconds.
Select Te mperature, press ENTER.
The device temperature is displayed.
To exit the menu, press MENU, or wait 30 seconds.
Select LED Use Hour, press ENTER.
Use UP/DOWN button to select Total LED Hour (total time) or LED On
Hour (current switch-on time), confirm your selection with ENTER.
The total time or current switch-on time is displayed.
Use UP/DOWN button to select LED Hours Reset, confirm your
selection with ENTER.
Use UP/DOWN button to set the password 050, confirm your selection
with ENTER. The LED operating hours is reset.
To exit the menu, press MENU, or wait 30 seconds.