5
system for safe operation. The amplier is designed to meet international safety standards
and complies with CE safety and electromagnetic compatibility requirements, as well as FCC
regulations.
This operating manual contains information, precautions, indications for cautions and warnings
which must be followed by the user to ensure safe operation and to keep the ACOM2000A in
safe operating condition.
PRECAUTIONS:
The EXPLICIT DEFINITIONS described below apply to this operating manual:
W A R N I N G notes call attention to a procedure which, if not correctly performed,
could result in personal injury, re hazard or electric shock.
C A U T I O N notes call attention to a procedure which, if not correctly performed, could
result in equipment damage, not only in the amplier.
N O T E notes call attention to a procedure which, if not correctly performed, could
result in inconvenience.
W A R N I N G HIGH VOLTAGE!
The amplier works with high voltages up to 3000V, which are LETHAL!
Also, for your safety, pull the amplier power plug out of the mains wall
outlet and WAIT AT LEAST 30 minutes EACH TIME BEFORE you remove
the cover of the amplier. Do not touch any part inside while the amplier
is open because some residual voltages may still be present.
W A R N I N G HIGH VOLTAGE!
Never allow anyone, ESPECIALLY CHILDREN, to push anything into
holes in the case - this will cause electric shock. NEVER TOUCH AN
ANTENNA during transmission - this may result in an electric shock or
burn. NEVER EXPOSE the amplier to rain, snow or any liquids. AVOID
placing the amplier in excessively dusty environments or in direct
sunlight. DO NOT OBSTRUCT AIR INTAKE (rear panel) and EXHAUST
(top cover) areas of the amplier. Keep a minimum distance of 10cm (4
inches) to the intake and 50cm (20 inches) to the exhaust.
W A R N I N G
Do not undertake on your own repairs or changes in hardware or software
of the amplier in order not to endanger your or other’s health and life
and not to damage the amplier and the equipment connected with it,
not covered by warranty. The manufacturer is not liable for another’s
actions and responsibility shall be assumed by the doer.
C A U T I O N
To avoid damage (not covered under warranty) read the Installation - Section 2
of this operating manual carefully. If you have any doubts about the installation,
operation or safety of the amplier, please consult your dealer.
To Next Page
Loading...
Need help?
General
