Need help?Do you have a question about the Acom 700S and is the answer not in the manual?
General| Type | Linear Amplifier |
|---|---|
| Cooling | Forced air |
| Tube | 4CX800A |
| Input Power | 50 W |
| Frequency Range | 1.8 - 54 MHz |
| Output Power | 700 W |
| Power Supply | 220 - 240 V AC, 50/60 Hz |
| Intermodulation Distortion | -30 dB |
| Harmonic and Parasitic Emissions | -50 dB |
| Input Impedance | 50 Ohms |
| Output Impedance | 50 Ohms |
Details the manual's purpose and provides an overview of the ACOM 700S linear amplifier.
Provides guidance on reading the manual, including informational notes and text symbols used.
Highlights the key features and capabilities of the ACOM 700S linear amplifier.
Covers production history and manual validity.
Lists other relevant documents for further information.
Explains how to identify the product using its label and serial number.
Lists the items included in the ACOM 700S amplifier package.
Details the optional accessories available for purchase with the ACOM 700S amplifier.
Explains how to contact ACOM or dealers for support and assistance.
Outlines safety precautions and defines signal words like DANGER, WARNING, CAUTION, and NOTICE.
Provides step-by-step instructions for unpacking and inspecting the ACOM 700S amplifier.
Offers guidance on choosing an appropriate location for installing the amplifier.
Covers selecting the correct line voltage for the amplifier.
Details the various connections on the amplifier's rear panel.
Explains how to connect transceivers, computers, and configure user settings via CAT/AUX.
Describes the initial power-on state and the low-energy standby mode of the amplifier.
Details the front panel components and their functions.
Provides the procedure for the initial power-on sequence of the amplifier.
Explains the information displayed on the amplifier's basic operational screen.
Describes the amplifier's control system, including buttons, menus, and their functions.
Guides the user through performing test transmissions to verify correct installation and operation.
Explains how to change between RX/TX, OPERATE/STANDBY modes, and configure AUTO OPERATE.
Details how to change frequency bands manually or automatically and the supported frequency ranges.
Provides instructions for operating the amplifier with compatible external antenna tuners.
Describes the amplifier's automatic protection levels (WARNING, SOFT FAULT, HARD FAULT).
Allows observation of eleven amplifier parameters, including power, SWR, and current.
Provides access to service functions for checking and adjusting amplifier circuits.
Enables configuration of CAT/AUX interface settings for transceiver communication.
Allows customization of amplifier settings such as automatic exit, beep volume, and call sign.
Displays information stored in memory about the last 28 HARD FAULT protection trips.
Offers options to restore factory default settings for user preferences, working hours, and error logs.
Explains remote control of the amplifier using the ACOM eBox Ethernet device.
Details how to control the amplifier remotely using the RS-232 serial interface.
Details periodic checks of connections, cables, SWR, and air filter cleaning.
Explains how to clean the amplifier exterior safely.
Provides instructions for safely replacing the primary mains fuses.
Describes how to download and interpret fault codes for diagnosing issues.
Provides information on firmware versions, prerequisites, and the update procedure.
Lists the technical parameters of the ACOM 700S, including frequency range and output power.
Details the amplifier's functions, including receive/transmit control and protection mechanisms.
Covers European conformity (CE) and US FCC regulations applicable to the amplifier.
Provides guidelines for amplifier storage environment, shipping size/weight, and transportation.
Offers guidance on the proper disposal and recycling of old electrical and electronic equipment.
To Next Page
