• Connect ACOM Terminal S to the amplifier by clicking on the Connect icon (two connected
plugs) or use Device -> Connect from the menu bar;
Figure 7-12 | Terminal S - Connect to amplifier
Figure 7-12 | Terminal S - Connect to amplifier
• When connected click on the Firmware Upload/Download icon (two arrows in opposite
directions) or use Device -> Firmware upload/download from the menu bar to activate the
Bootloader;
Figure 7-13 | Terminal S - Firmware Upload/Download
Figure 7-13 | Terminal S - Firmware Upload/Download
When the bootloader has been activated there will be beeps from the amplifier and the
front display will go black.
To Next Page
Loading...
