Acom 700S - Figure 7-20 | Terminal S - Exit Process

User's Manual | ACOM 700S | 1.8-54 MHz Linear Amplifier
April 2024
S e c t i o n MAINTENANCE | Page 75 of 92
• Press the E letter from your keyboard to exit from the process. Click on the Disconnect icon
(two separated plugs) or use Device -> Disconnect from the menu bar to disconnect from the
amplifier. Click on the File -> Quit from the menu bar to close Terminal S;
Figure 7-20 | Terminal S - Exit process
Figure 7-20 | Terminal S - Backup firmware process
• Push and hold for 1-2 seconds the POWER button to restart the amplifier and enter STANDBY
mode.
You can check the current firmware version in the amplifier's menu FAULT LOG (see Section
5.5 Menu FAULTS LOG);
• Push the POWER button to turn off the amplifier (back to low energy STANDBY mode);
• Switch off the amplifier via Main Power Rocker Switch (see Figure 2-4 | Rear panel -
Connections, Pos. 1); Make sure the Main Power Rocker Switch is in OFF position;
• Pull the line (mains) plug out of the outlet;
• Disconnect "USB to RS-232" converter or RS-232 cable;
• Follow the instructions in Section 2.4 Connections to re-connect the amplifier to your station.