Acom AC-100 - Options & Accessories; Troubleshooting & Error Messages

12
The Number in the Count display represents the high limit for
Limit Counting. When you are counting:
if the Current Count >
High then the Limit Lamp will flash and
the scale will continuously beep.
4. Enter the high limit using the numeric keys. If you do not want a
high limit press the C key.
5. Press the SET key.
To disable the use of Limit Mode simply enter 0 as the low limit and 0
as the high limit.
Options & Accessories
The following options are available through your ACOM Authorized
dealer:
Description Part Number
Spill-Proof Overlay (Wet cover) 101-00001-020000
AC Power cord 690-00001-02002M
Adjusting feet (set of 4) 4B0-00001-020000
For any type of service or troubleshooting, please contact your nearest
ACOM Authorized dealer. DO NOT attempt to service , repair, or
disassemble this or any scale as this is legally permissible to only
licensed professionals.
Troubleshooting & Error Messages
Error
Description
Solution
Zero Initial zero range error
Empty the platter, turn OFF and ON.
If this occurs again then call service
AdC Analog circuit failure Call service
EEP Memory failure Call service
PArA Parameter failure Call service
For more information go to:
http://www.acomamerica.com/techs.htm#AC-100%20Techs