Acom AC-100 - Program Mode; Programming PLUs by Sample

9
9. The Count display above shows 5000 as an example.
The number in the Count Display represents the Running Tota
l
Count.
The Number in the Unit Weight display shows the number o
f
batches that have been added to the Running Total Count.
10. If you wish to add more batches then press the SUM and return
to step 2; otherwise, you can press the C key to clear the current
Running Total and start a new one.
When the Acc Lamp is on, it means that there is an active Running
Total.
Program Mode
Programming PLUs by Sample:
1. Make sure the Zero and Stable Lamps are on.
2. Select the weighing unit you wish to use by pressing the WEIGHT
CONV. Key.
3. Place the parts that you wish to count on the platter.
4. Enter the number of parts that you placed on the platter by using
the numeric keys. You cannot use the decimal key.
5. Make sure that the Stable Lamp is on.
6. Press the SAMPLE key.
7. Press the M! key. The displays will show:
8. Enter the tare weight for this PLU using the numeric keys. You
may use the decimal key if necessary. Keep in mind the weighing
unit (pounds or grams) for this PLU when you enter the tare.
9. Press the M! key. The displays will show:
tArE
0
Unit
0