7
Platter Tare Entry
1. Make sure the Zero and Stable Lamps are on.
2. Select the weighing unit you wish to use by pressing the WEIGHT
CONV. Key.
3. Place the item you wish to tare onto the platter.
4. Make sure that the Stable Lamp is on.
5. Press the TARE key.
Counting by Unit Weight Entry
1. Make sure the Zero and Stable Lamps are on.
2. Follow the platter or manual tare entry procedures if necessary.
3. Place the parts that you wish to count on the platter.
4. Type the unit weight. You may use the decimal key if necessary.
Remember that when you are in pound mode you are
entering the Unit Weight for 1000 pieces not for 1 piece.
5. Make sure that the Stable Lamp is on.
6. Press the UNIT WEIGHT key.
Steps 3 & 4 can be interchanged. The scale will now display a unit
weight and a count. The scale may also flash the Ls or Lu Lamps
depending on certain criteria specified on page 4. You can begin
counting.
Counting by Sample Entry
1. Make sure the Zero and Stable Lamps are on.
2. Follow the platter or manual tare entry procedures if necessary.
3. Place the parts that you wish to count on the platter.
4. Enter the number of parts that you placed on the platter by using
the numeric keys. You cannot use the decimal key.
5. Make sure that the Stable Lamp is on.
6. Press the SAMPLE key.
Steps 3 & 4 can be interchanged. The scale will now display a unit
weight and a count. The scale may also flash the Ls or Lu Lamps
depending on certain criteria specified on page 4. You can begin
counting.
To Next Page
Loading...
Need help?
General
