Acom JW-1 User Manual

13
Enable & Disable Weighing Units
Use the following procedure to enable or disable individual weighing
units.
1. Make sure that the scale is plugged into a proper outlet, the
platter is properly seated, there is nothing on the platter, and
that the Power Switch is OFF.
2. Press and hold down the ¿ key while you turn the Power
Switch is ON.
3. The display will read: up-.
4. Press the MODE key and then the ¿ key. The display will
read: st-mod.
5. If you want to Enable g weighing press SET; to Disable g
press the MODE key.
6. If you want to Enable Pcs weighing press SET; to Disable Pcs
press the MODE key.
7. If you want to Enable % weighing press SET; to Disable %
press the MODE key.
8. If you want to Enable c.t. weighing press SET; to Disable c.t.
press the MODE key.
9. If you want to Enable oz weighing press SET; to Disable oz
press the MODE key.
10. If you want to Enable lb weighing press SET; to Disable lb
press the MODE key.
11. If you want to Enable dwt weighing press SET; to Disable dwt
press the MODE key.
12. If you want to Enable Gn weighing press SET; to Disable Gn
press the MODE key.
13. If you want to Enable kg weighing press SET; to Disable kg
press the MODE key.
14. If you want to Enable toz weighing press SET; to Disable toz
press the MODE key.
15. If you want to Enable t weighing press SET; to Disable t press
the MODE key.
16. Now press the MODE key 5 times and the balance will run the
display test and go to Zero.
17. Press the MODE key once then turn the Power Switch is OFF
and then back ON.
18. You are done!
For more information go to:
http://www.acomamerica.com/techs.htm#JW-1 Techs

Acom JW-1 Specifications

General

Brand	Acom
Model	JW-1
Category	Scales
Language	English