Acorn Ltl 5210A

- 9 -
reference to 3.1 Parameter Settings in the Advanced Operation
section.
Under the test mode, one useful function you would like is testing
the work area of the PIR (Passive Infrared) sensor, specifically the
sensing angle and monitoring distance. To perform the test:
 First strap the camera on a tree aiming the region of
interest (ROI).
 Walk slowly from one side of the ROI to the other
parallel to the camera. Try different distances and angles
from the camera.
 If the Motion Indicator flashes blue, it indicates the
position from where you were detected by one of the
side Prep PIR sensors. If the Motion Indicator flashes
red, it indicates the position from where you were
captured by the main PIR sensor.
By doing this test, you can find the best placement when mounting
and aiming the Our scouting camera. In general, you are
recommended to place the camera 3 to 6 feet (1 to 2 meters) above
the ground.
To avoid potential false triggers due to temperature and motion
disturbances, please do not aim the camera at a heat source (i.e.
the sun) or nearby tree branches and limbs. The ideal direction to
aim at is North or South. Also, remove any limbs close to the front
of the camera.
2.4 Enter Live Mode