SERVICE MODE
To enter the Service Mode: 1. Open the Door (Fan motor running and colon in the display).
2. Press and Hold #3 Pad until “SERVICE” is displayed.
3. Press pad # from following list (to change selection.
(Press “STOP” Pad and the next Pad #)
Pad 1 = Magnetron Hours
Pad 2 = Door Cycles
Pad 3 = Manual Cycles (“Time Entry” Cycles)
Pad 4 = Latch Cycles
Pad 5 = Cycle Count for Each Pad. After pressing 5, pressing another
Pad # will display the number of times that Pad has been used.
Pad 6 = Call Service Alarm On or Off. To save a change, Press the
“START” Pad.
Pad 7 = 50:7 Fan = Cooling Fan and Exhaust Fan run Together
50:7 Ant = Exhaust Fan only Runs During a Cook Cycle
Pad 8 = Total Cycle Count
Pad 9 = n/a
Pad 0 = Press and Hold to CLEAR CALL SERVICE
To Next Page
Loading...
