INSTALLATION INSTRUCTIONS
If you would prefer to use a larger hose in order to pump
water away more quickly, attach the included adaptor (B)
to pump (A), and then securely attach the Hose Kit
(not included) to the adaptor (B).
WARNING: Secure the discharge hose before plugging
in the pump. Pump torque may cause an unsecured
discharge hose to “whip”, possibly causing personal
injury and/or property damage.
Plug the pump (A) into a 115 volt GFCI power outlet.
WARNING: Do not let plug fall in water and do not stand
in water while the pump (A) is plugged in.
The pump (A) will start operating when the power cord is
plugged into the outlet.
OPERATION INSTRUCTIONS
NOTICE: Make certain you unwind the garden hose completely. Kinks in the hose will
restrict the pump, preventing it from priming, which is the first step to pumping water.
The water level must be at 1 in. for the pump to prime and operate.
Once the pump (A) has removed the water down to 1/4 in.,
unplug the pump. CAUTION: Failure to unplug it will result
in the pump going into thermal overload.
CAUTION: Do not run the pump (A) dry. Operating the pump
(A) without water will cause damage to seals and will cause
the pump (A) to fail, thereby voiding the pump's warranty.
Remove the pump (A) and hose from the location when finished pumping, as the hose still has
water that can drain back through the pump. Remove remaining water with squeegee, mop,
sponge, towel, wet/dry vac, etc.
2.
1.
5
2
B
A
B
A
1
A
To Next Page
Loading...
Need help?
General
