MOB USER MANUAL
16 Y1-03-0283 Rev. C
When the programming is complete, the screen will
change. Remove the MOB and check that the LED
starts flashing green. Turn the MOB off by pressing
the “TEST/OFF” key for one second. The LED will
blink red twice. Press the <F12> key to exit the
programming mode.
If the programming fails, the LED will start flashing
red after a short period of time. Turn the unit off by
pressing the “TEST/OFF” key and retry.
When programming is complete, your MOB is now ready for fitting to the life jacket
(section 3) for use.
NOTE: Make sure the display screen is set to full brightness before commencing
programming the MOB.
5. OPERATION
WARNING: Use only in situations of grave and imminent danger.
Misuse may result in a severe penalty.
Ensure that your MOB is always fitted with an unused battery that is within the marked
expiry date. Failure to do so may result in reduced operating time when used in a real
emergency. Please observe the recommendations on testing in section 7.
5.1 Automatic Activation
When correctly packed in a life jacket, the MOB will automatically activate when the life
jacket inflates. Should the life jacket fail to fully inflate, it may be necessary to assist the
Activation Slide by pulling on the Activation Tape to fully release the Activation Slide.
5.2 Manual Activation
Only activate your MOB in situations requiring assistance ONLY in an
emergency. Deliberate misuse of your MOB may result in a fine.
To manually activate your MOB in an emergency, slide the grey Activation Slide to
the left or right over the left or right Arming Retainer. The antenna will deploy and
the light will start flashing. The MOB will automatically start transmitting after 15
seconds.
The antenna is automatically released. Keep the MOB well away from your eyes
when activating.
If the MOB fails to activate when the slide is removed, press the “ON” key down until
the green LED starts flashing. Release the key.
To Next Page
Loading...
