What to do if my Acson international Air Conditioner does not work?
If your Acson international Air Conditioner isn't working, start by checking the power supply. It could be a power failure or a blown fuse. Also, ensure the power plug is properly connected. Finally, verify that the delay timer is correctly set.
How to increase airflow in my Acson international Air Conditioner?
If the airflow from your Acson international Air Conditioner is too low, the first thing you should do is clean or replace the air filter. Also, make sure that doors and windows are closed. Finally, check the suction and discharge for any clogs and clear them.
Why is the remote control light dim on my Acson international Air Conditioner?
If the remote control light of your Acson international Air Conditioner is dim, it likely means the batteries are low. Replace the batteries. If that doesn't work, ensure the batteries are correctly inserted.
How to get rid of bad odor from Acson international Air Conditioner?
If your Acson international Air Conditioner emits a bad odor, it's likely due to particles like cigarette smoke or perfume that have adhered to the coil. Clean the coil to remove these odors.
Why is there condensation on my Acson international Air Conditioner?
Condensation on the front panel of your Acson international Air Conditioner is often due to air humidity after prolonged use. Allow the unit to stabilize. If the condensation persists, the set temperature might be too low. Try increasing the temperature and setting the fan to high.
Why Acson international Air Conditioner compressor does not work after starting?
If the compressor of your Acson international Air Conditioner doesn't start immediately, it might be due to a built-in protection against frequent starting. Wait for 3 to 4 minutes to see if it starts.
Details on how to securely mount the indoor unit using hanging rods and adjust its height.
Procedures for correctly installing the drain pipe to ensure smooth drainage and prevent leaks.
Site selection criteria for the outdoor unit, focusing on protection, load capacity, and airflow.
Guidance on installing the outdoor unit firmly and horizontally, maintaining clearance.
Recommendations on piping length, elevation, bends, and pipe sizes for optimal performance.
Steps for connecting refrigerant pipes, emphasizing cleanliness, brazing, and leak prevention.
Table specifying the required additional refrigerant charge based on piping length.
General| Refrigerant | R32 |
|---|---|
| Type | Split Air Conditioner |
| Cooling Capacity | 2.0 kW |
| Power Supply | 220-240V, 50Hz |
| Net Weight (Indoor Unit) | 8 kg |
| Net Weight (Outdoor Unit) | 25 kg |
To Next Page