What to do if my Acson international Air Conditioner does not work?
If your Acson international Air Conditioner isn't working, start by checking the power supply. It could be a power failure or a blown fuse. Also, ensure the power plug is properly connected. Finally, verify that the delay timer is correctly set.
How to increase airflow in my Acson international Air Conditioner?
If the airflow from your Acson international Air Conditioner is too low, the first thing you should do is clean or replace the air filter. Also, make sure that doors and windows are closed. Finally, check the suction and discharge for any clogs and clear them.
Why is the remote control light dim on my Acson international Air Conditioner?
If the remote control light of your Acson international Air Conditioner is dim, it likely means the batteries are low. Replace the batteries. If that doesn't work, ensure the batteries are correctly inserted.
How to get rid of bad odor from Acson international Air Conditioner?
If your Acson international Air Conditioner emits a bad odor, it's likely due to particles like cigarette smoke or perfume that have adhered to the coil. Clean the coil to remove these odors.
Why is there condensation on my Acson international Air Conditioner?
Condensation on the front panel of your Acson international Air Conditioner is often due to air humidity after prolonged use. Allow the unit to stabilize. If the condensation persists, the set temperature might be too low. Try increasing the temperature and setting the fan to high.
Why Acson international Air Conditioner compressor does not work after starting?
If the compressor of your Acson international Air Conditioner doesn't start immediately, it might be due to a built-in protection against frequent starting. Wait for 3 to 4 minutes to see if it starts.
Technical details for the indoor component of the split systems.
Technical details for the outdoor component of the split systems.
Cooling capacity (kW) for various indoor/outdoor conditions.
Electrical schematics for indoor units in cooling-only configurations.
Electrical schematics for outdoor units in cooling-only configurations.
Electrical schematics for indoor units in heat pump configurations.
Electrical schematics for outdoor units in heat pump configurations.
Electrical diagrams for indoor units using a universal control board.
Electrical diagrams for outdoor units using a universal control board.
Introduction to R407C refrigerant, its properties, and comparison to R22.
Details on R407C composition, mixture behavior, and POE oil requirements.
Essential checks for tubing, compressor oil, refrigerant, and tools.
Precautions for R407C system handling, including filter-dryer and moisture avoidance.
Steps for mounting the indoor unit, including dimensions and ceiling preparation.
Detailed steps for hanging the unit, adjusting height, and ensuring stability.
Instructions for drain pipe installation, insulation, and leak testing.
Recommendations for optimal piping configuration to maintain capacity and reliability.
Procedures for connecting pipes, ensuring cleanliness, and proper brazing techniques.
Guidelines for calculating and adding refrigerant based on pipe length.
Requirements for field wiring, compliance with local codes, and wire diameters.
Safety guidelines for wiring, grounding, connections, and avoiding contact with hot parts.
Procedures for cleaning or replacing the air filter.
Table listing common malfunctions and their potential causes for quick diagnosis.
General| Brand | Acson international |
|---|---|
| Model | ALC 20BR |
| Category | Air Conditioner |
| Language | English |
To Next Page