What to do if my Acson international Air Conditioner does not work?
If your Acson international Air Conditioner isn't working, start by checking the power supply. It could be a power failure or a blown fuse. Also, ensure the power plug is properly connected. Finally, verify that the delay timer is correctly set.
How to increase airflow in my Acson international Air Conditioner?
If the airflow from your Acson international Air Conditioner is too low, the first thing you should do is clean or replace the air filter. Also, make sure that doors and windows are closed. Finally, check the suction and discharge for any clogs and clear them.
Why is the remote control light dim on my Acson international Air Conditioner?
If the remote control light of your Acson international Air Conditioner is dim, it likely means the batteries are low. Replace the batteries. If that doesn't work, ensure the batteries are correctly inserted.
How to get rid of bad odor from Acson international Air Conditioner?
If your Acson international Air Conditioner emits a bad odor, it's likely due to particles like cigarette smoke or perfume that have adhered to the coil. Clean the coil to remove these odors.
Why is there condensation on my Acson international Air Conditioner?
Condensation on the front panel of your Acson international Air Conditioner is often due to air humidity after prolonged use. Allow the unit to stabilize. If the condensation persists, the set temperature might be too low. Try increasing the temperature and setting the fan to high.
Why Acson international Air Conditioner compressor does not work after starting?
If the compressor of your Acson international Air Conditioner doesn't start immediately, it might be due to a built-in protection against frequent starting. Wait for 3 to 4 minutes to see if it starts.
Chart showing allowable indoor and outdoor temperature ranges for cooling-only operation.
Charts showing allowable temperature ranges for heat pump heating and cooling modes.
Wiring schematics for indoor and outdoor units using C3A boards.
Wiring schematics for indoor and outdoor units using Universal boards.
Wiring diagrams for specific outdoor units: 60Hz, 3 Phase, High Ambient, Low Ambient.
Explains R407C properties, ozone depletion, and lubricant requirements.
Details precautions for compressor exposure, vacuum levels, liquid withdrawal, and servicing leaks.
Guidelines for site selection, electrical supply, and unit placement considerations.
Instructions for mounting the indoor unit, including dimensions and clearance requirements.
Instructions on hanging the unit using rods, adjusting height, and ensuring it is level.
Guidelines for selecting a suitable outdoor location, considering protection and ventilation.
Instructions for installing the outdoor unit firmly and horizontally with specified clearances.
Recommendations for piping length, elevation, bends, and pipe sizes to maintain capacity.
Steps for connecting refrigerant pipes, including brazing, cutting, deburring, and tightening.
Table detailing required additional refrigerant charge based on pipe length for cooling only models.
Table detailing additional refrigerant charge for heat pump models based on pipe length.
Emphasizes compliance with local electrical codes for wire diameters and installation.
Key safety and installation practices for electrical wiring, including grounding and connections.
Operation guide for the G6 remote controller, including modes and settings.
Operation guide for SLM and AC-5300 remote controllers, covering their features.
Operation guide for the G8 remote controller, detailing all functions.
Recommended maintenance tasks for air filters, indoor unit, drain pan, coils, and power supply.
Table listing common air conditioner faults, their causes, and simple troubleshooting steps.
General| Brand | Acson international |
|---|---|
| Model | ALC 15B |
| Category | Air Conditioner |
| Language | English |
To Next Page