125
Troubleshooting AWM-G-2009
Indicator Lights
AWM / A5WM - G SERIES
IR Signal Receiver
When there is infrared remote control operating signal, the signal receiver on indoor unit will made a (beep)
for signal acceptance confi rmation.
Cooling unit / Heatpump unit
The table below shows the LED indicator light for air conditioner unit under normal operation and fault condition.
The LED indicator lights are located at the middle of the air conditioner unit.
The heat pump units is equipped with an “auto” mode,where by the unit will provide reasonable room temperature
by switching the unit automatically to either “cool” mode or “heat” mode, according to the temperature setting
set by the user.
LED Indicator Lights for Cooling Unit / Heatpump
Unit
To Next Page
Loading...
Need help?
General
