ACT5prox Operating and Installation Instructions
6
Step Keypad Entry Operation
10 Change Programming code (Default 9999)
2 Press
✔
3 0000-9999 New 4 digit programming code
Change Programming Code: Enter Programming Mode, then Press
Step Keypad Entry Operation
12 Set Door Relay Time – (default 5 seconds, maximum 255 seconds)
20 Buzzer sounds indicating timing… wait required period
3
✔
End setting Door Relay Timer
Set Door Relay Time: Enter Programming Mode, then Press
Step Keypad Entry Operation Example: Assign Toggle made to user 12
11 Set Toggle Mode
✘
9999 Enter programming
2 00-49 Enter 2 digit User Number 00-49 1 Set Toggle Mode
3 0 or 1 0 = Relay Toggle, 1 = Relay Timed 12 User 12
0 Relay toggle
✘
Exit programming
Set Toggle Mode: Enter Programming Mode, then Press
Step Keypad Entry Operation Example: Delete user 10’s card
16 Delete User’s Card
✘
9999 Enter programming
2 00-49 First user to delete 6 Delete cards
3 00-49 Last user to delete 10 User 10
10 User 10
✘
Exit programming
Deleting Userʼs Card: Enter Programming Mode, then Press
Step Keypad Entry Operation
17 Delete card number
2 10 digit card number 10-digit Card number with leading zeroes.
Eg. Card 54321, enter 0000054321
Deleting Card Number: Enter Programming Mode, then Press
Step Keypad Entry Operation
1 80 Check if user has no PIN already assigned
2 00-49 User 0-49
Keypad will flash the green led and sound high-pitched tone if the user has NO
PIN code assigned. It will flash red and sound low-pitched tone, if the user has
a PIN code.
Check if User has no PIN Assigned: Enter Programming Mode, then Press
To Next Page
Loading...
