ACT ACT10 DIGITAL KEYPAD User Manual

ACT10 DIGITAL KEYPAD
30 SECOND PROGRAMMING GUIDE
(for typical system)
1. Enter Programming Mode.
Press X button followed by the programming
code (9999)
The yellow indicator should be flashing
2. Change User 1 code.
Press 0, then 1 followed by the new user 1 code
(four digits)
3. Change Programming Code.
Press 0, then % followed by the new program-
ming code (four digits).
4. Set Desired Relay Active Time .
Press 2, then 0. Allow the buzzer to sound for
the desired period. Press % to stop – this pe-
riod is now programmed into the relay timer.
5. Exit Programming Mode.
Press the X button. The yellow LED should
stop flashing.
The keypad is now ready for normal use.
Note: The keypad may be returned to its factory
default condition at any time by entering the pro-
gramming mode and pressing the % three times.
For information on programming the advanced
features of the keypad, please refer to the complete
programming guide on the other side of this sheet.
IMPORTANT
As with any access control system, always ensure that there is
an alternate means of escape in the event of the unit failing to
operate due to power loss or in the event of fire.
Unit 8, IDA Business Park,
Whitestown, Dublin 24, Ireland.
Tel: 353-1-4622585 Fax: 353-1-4622587
Copyright  1999 Access Control Technology Ltd.
(18-00001-02)
INSTALLATION NOTES
• Always remember to factory default the controller before
you start programming.
• Always remember to place the supplied Varistor
across the terminals of the door strike coil to protect
the relay contacts.
• Never use the onboard relay to switch AC mains voltage.
An external relay isolated electrically from the ACT10
should be used for this purpose.
• Don’t forget to change the programming code to some-
thing known only to yourself.
For full details on the ACT product range and a list of distributors,
Visit our website www.accesscontrol.ie
Downloaded from: http://www.guardianalarms.net

ACT ACT10 DIGITAL KEYPAD Specifications

General

Product Type	Digital Keypad
Mounting	Surface Mount
IP Rating	IP65
Operating Temperature	-10°C to +50°C
Number of Keys	12
Key Material	Metal
Interface	Wiegand

Summary

30 Second Programming Guide

Programming Mode Entry and Exit

Procedure to enter and exit programming mode, with yellow LED indication.

Changing User and Programming Codes

Steps to change user codes and the master programming code.

Setting Relay Active Time

How to configure the duration for the relay timer.

Installation Notes

Important considerations for installing the ACT10 controller.

Important Safety Information

Crucial advice regarding power loss and escape routes.

ACT10 Digital Keypad Programming and Options

Programming Mode and Code Management

Details on entering programming mode and managing user/programming codes.

Setting Switched Output Combinations

Configuring how outputs function for different users.

Setting Timers

Adjusting durations for relay, door ajar, and guest buzzer timers.

Configurable Keypad Options

Setting various operational features like backlighting, alarms, and codes.

Restoring Factory Defaults

Procedure to reset the keypad to its original factory settings.

Typical ACT10 Wiring Configuration

Input and Output Connections

Diagram illustrating connections for doors, buttons, tamper, and outputs.

Power Supply and Buzzer Connections

Wiring details for power input and guest buzzer output.

Outdoor Installation Guidelines for ACT10 Keypad

Installation Precautions

Advice on sealing and protecting the keypad from environmental factors.

Weather Protection Recommendations

Guidance on using weather cowls for exposed or uneven surfaces.