Need help?Do you have a question about the ACT 612 and is the answer not in the manual?
General| Brand | ACT |
|---|---|
| Model | 612 |
| Category | Test Equipment |
| Language | English |
Instructions for setting the calibration control for Standby SLA batteries.
Instructions for setting calibration control for Cyclic GEL batteries.
Instructions for setting calibration control for car FLOODED (Wet Cell) batteries.
Procedure for calibrating the tester to non-standard battery types.
Device startup sequence showing surface charge removal.
Reminder to check and adjust the Ah calibration for the battery type.
Display and record the battery's voltage reading.
Initiate the Ah capacity test by pressing the test button.
Display and record the measured Ah capacity of the battery.
Indicates the test procedure has finished.
Guidance on when to recharge or replace a battery based on capacity.
Alert for low battery voltage or capacity, requiring attention.
Advice on checking battery age and avoiding purchasing discharged batteries.
Importance of checking voltage in new batteries before use.
Recommended voltage range for fully charging SLA batteries.
Information on how temperature affects battery performance and lifespan.
To Next Page
